Loosen throughout this adjustment. Now, loosen the 10mm nut in the center of the clutch mechanism, and again at the center of the screw a few turns. Now he screwed into the greatest attention to the impression of coming into contact with the push rod clutch inside the motor. Make it a little to take the whole game the system. The purpose here is to take the whole game the system without any pressure on the engine to push the clutch rod. When you feel you are at this point, back the screw a quarter turn and tighten the nut around the screw 10mm.
If you can, hold the screw with the screwdriver and tighten the nut with a wrench, if you want to ensure that the setting has not changed by tightening the nut 10mm. You should now have some slack in the system. If not, you burn the clutch now! Now you can adjust the handle playing with the cable adjustment. 3 / 8-1 / 2 inches is what you need on the handle tip. Replace the ignition cover and the fairing and you're ready to go!
You can download this book motorcycle installation manual Yamaha YSR 50 Racing Clutch Kit Instruction.pdf from the original website here www.powerbrokerz.com
Download wallpapaer here : Yamaha YSR 50 Racing
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.